2-Axis Solar Panel Control very flexible

This script is able to handle orientation of the solar panels dataport towards either 90° or 270° and it will also handle sensor orientation in all directions

If your panel's dataport is on the east side (90°) set d0 to one of your panels If your panel's dataprot is on the west side (270°) set d1 to one of your panels If both d screws are set, the script will use the 90° setting, so don't do it ;-) To change the settings after you run the program, remove the IC10 chip. Otherwise it will not reinitialize.

If your sensor's dataport is on west side (270°) set d2 to your sensor If your sensor's dataport is on the south side (180°) set d3 to your sensor If your sensor's dataport is on the east side (90°) set d4 to your sensor if your sensor's dataport is on the north side (0°) set d5 to your sensor

All panels must be of the same type.

After sunset the panels will turn towards the sunrise position.

The efficiency should be the maximum possible in my opinion.