Autom. Filtration + Filter status

What does the program do?

It checks whether the gas, which can be filtered by the connected filtration units, is inside the pipes and starts the needed filtration unit. Additionally the filters inside the filtration units get checked and their usage will be written to a diode slider

Which devices are needed?

• 1 or 2 Filtration units
• 1 Pipe Analyzer
• 1 or 2 Dioden Slider
• 1 IC Housing
• 1 programable Chip

Connection

The program will label the screws with a yellow hint, so you can easily see on which screw the program expects which device. The filtration units are labled with A and B, same as the diodes. You have to keep an eye on matching filtration unit A with diode A, same for B (otherwise the diode will be written on the wrong filter usage).

Config

In the program you can config RatioA and RatioB after the "alias" statements. Here you have to enter the gases which can be filtered by the filtration units. Again check for A to A and B to B. When you don't have a filtration unit B you can enter whichever gas you want (or keep the set one) as it won't be checked.