FiltrationUnit IC Controller

Here I present you a filtration unit controller, that has to be written onto an IC10 in the filtration unit.

The controller looks at the type of the inserted filter(s) - can be two different types (size and/or gas) - and waits for a GasRatio at the input pipe. As long as there are moles of the filter's type at the input the filtration unit is activated. If there is nothing to filter, the filtration unit is switched into Idle-Mode. The filters can be hot-swapped at runtime and the controller reacts accordingly.

Optional: On D0 and D1 you can attach a Diode Slide / LED / LED Display (small/medium/large) (in any combination). If there are two devices attached, then D0 shows durability of filter 1 and D1 shows durability of filter 2. If there is only one device attached, it shows the average of both filters. Attention: Changing D0/D1 while the filtration unit is switched on will very likely break the code as the devices are updated in every tick. So always switch it off before changing something.

A Diode slide shows a percentual bar. A LED shows a color dependent on durability. A LED-Display shows the durability as a %-Value in a color dependent on durability.

Devices are switched on when the filtration unit is Activated, and switched off when the unit is Idle.

The Colors and Tresholds are: >98%..100% - blue >50%..98% - green >15%..50% - orange 0%..15% - red They can be adjusted to your liking at the end of the script.​