Simple Power Display

Introduction

I needed to get the average ratio of my batteries bank so my IC10 controlling my Stirling's input will turn on and off on demand. Since I am already getting codes going, might as well make a detail stats display as well. The part related to my Stirling's is not included, this is just pure Power Stats Display

Features

• Shows overall batteries ratio. It will change color to red if below 30%, to green if above 75% and otherwise yellow.
• Show the difference between incoming and outgoing power. Green if is net gain. Red if is losing power.
• Show real time (MM.SS) how long before batteries depleted or filled. This fluctuate a lot as it is real time. Green is time to full. Red is time to complete depletion

Requirements

• d0 - LED small, power ratio display
• d1 - LED small, power gain or loss
• d2 - LED small, time to full or deplete
• d3 - Cable analyzer, placed at input of the batteries bank to obtain incoming power

Limitations

This IC10 is code based on a very simple batteries bank setup where batteries are built in parallel thus putting an cable analyzer on that one cable is enough to know your entire power generation throughput. If you build batteries all over the places, this IC10 is not for you.