Smart Canister Load System

WHAT THIS DOES: This system will auto fill your smart canister with whatever gas you're pushing to it.

WHY THIS DOES IT: Because I wanted a way to plug in my smart canisters, press a button, and have it auto fill the canister with the gas I'm pushing to it.

WARNING: This will make regular canisters EXPLODE. Unless that's your goal, only use Stationeers Approved Smart Canisters (SASC is so close to SACS, I tried to make something work for the joke, but couldn't come up with something)

Requires: Volume Pump Canister Storage LED Logic Switch(Button) IC(Duh)

The Setup: 1. Whatever Gas You Want > Volume Pump > Canister Storage 2. Have Button, IC, LED, Volume Pump, Canister Storage on same cable network. 3. Copy code to chip (Computer with IC Motherboard not included) 4. Plug Chip into IC. 5. Turn on IC 6. Observe Error (You gotta set devices). 7. Also observe that device names are now set to screws 8. Screw the IC until the devices stop back talking 9. Turn IC off and on again. 10. Plug in Smart Canister and press button.

Light will go through the standard lighting of stationeers:

Red, Blinking: no canister Red: Below 5000kpa Orange: Below 10000kpa and above 5000kpa Yellow: Below 14000kpa and above 10000kpa Green: Below 19000kpa and above 14000kpa Blue: above or equal to 19000kpa.

The system will turn off when it hits blue. The Smart canisters can hold 20000kpa, but I don't wanna push it, I'd rather leave you 1000kpa in the event of a hot planet. (I'm on europa, so nbd for me)

Let me know if you have any feedback or find any bugs. I can upload one for regular canisters if people want. Also, if you want to use a switch instead of a button, you have to adjust line 69 to "Open" instead of "Setting"

Cheers.