Temperature Management

# Temperature Management

Source available on GitHub: https://github.com/RoboPhred/stationeers-mips/tree/master/temperature-management

## Description

Monitors the temperature of a gas sensor and mantains temperature through the use of coolers and heaters.

## Features

- Shmitt triggered - Supports batch writers and direct wall heaters / wall coolers - Optional external temperature control - Status reports via Status output.

## Devices

1. GasSensor Type: _Gas Sensor_ The gas sensor to measure the temperature from 2. Heater Type: _Memory_ or _Wall Heater_ The device to turn on when the room needs to be heated. For batch writer use, attach a memory cell, and attach the cell to a batch writer. 3. Cooler Type: _Memory_ or _Wall Heater_ The device to turn on when the room needs to be cooled. For batch writer use, attach a memory cell, and attach the cell to a batch writer. 4. DesiredTemperatureDevice _optional_ Type: _Memory_ or _Dial_ The external source to specify the temperature. By default, this is Celcius, but can be Kelvin by a config option.

## Configuration

- `DesiredTemperature` Default: _295.15 Kelvin, 22 Celcius_ The target temperature to mantain in Kelvin. - `Threshold` Default: _1 Kelvin / Celcius_ The offset in degrees Kelvin to allow the temperature to differ from DesiredTemperature before trying to correct it. - `ExternalDesiredTempUnits` Default: _1_ (Celcius mode) The units to expect the value from DesiredTemperatureDevice in. If 1, use Celcius, if 0, use Kelvin. - `CheckInterval` Default: _1_ The time in seconds to wait between temperature checks.

## Status codes

- `-1`: Cooling - `0`: Idle - `1`: Heating