Terranovum Dynamic Energy

TERRANOVUM DYNAMIC ENERGY - MOD

A real-time power-management LCD system for Space Engineers.

Update 20/10/2026

LCD Graphics Update

DISPLAYS

The pack contains one general WIDE display and four dedicated STD displays:

• ENERGY COMMAND — general grid power overview • WIND ARRAY — wind turbine data • SOLAR ARRAY — solar panel data • H2 ENGINE — hydrogen engine data • BATTERY BANK — battery storage and charge data

REAL DATA SHOWN

ENERGY COMMAND: • Total Production • Total Consumption • Net Balance • Batteries online / total • Solar Output • Wind Output • Stored Power • Battery Charge %

Total Production uses the live output of all non-battery power producers on the same construct. Total Consumption is calculated from real producer output plus battery discharge minus battery charging, representing the actual delivered electrical load. Net Balance shows the live surplus or deficit being absorbed/supplied by the battery bank. Dynamic Energy includes the real-time power produced by reactors total energy production. For detailed reactor data, use the separate Terranovum Dynamic Reactor mod.

WIND ARRAY: • State • Turbines online / total • Current Output • Max Output

SOLAR ARRAY: • State • Panels online / total • Current Output • Max Output

H2 ENGINE: • State • Engines online / total • Current Output • Max Output

BATTERY BANK: • Charge Mode • Batteries online / total • Current Input • Current Output • Stored Power • Charge %

LCD TAGS

Rename the LCD panel with one of these tags:

- [TI ENERGY WIDE]
Displays the general ENERGY COMMAND widescreen overview.
- [TI ENERGY WIND]
Displays the WIND ARRAY STD panel.
- [TI ENERGY SOLAR]
Displays the SOLAR ARRAY STD panel.
- [TI ENERGY H2]
Displays the H2 ENGINE STD panel.
- [TI ENERGY BATTERY]
Displays the BATTERY BANK STD panel.

The system reads blocks on the same mechanically connected construct, allowing normal rotor, piston and hinge subgrids.